Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

B1344 Engine Trouble Code

Meaning of B1344 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B1344 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for B1344 code is occuring now you should check B1344 repair processes.
Now don't ask yourself; What should you do with B1344 code ?
The solution is here :

B1344 Possible Solution:

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

B1344 Code Meaning :

B	1	3	4	4
OBD-II Diagnostic Body (B) Trouble Code For Engine	Fuel And Air Metering	Throttle/Pedal Position Sensor/Switch A Circuit Intermittent	Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)	Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B1344 OBD-II Diagnostic Body (B) Trouble Code Description

B1344 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For B1344 Code

The reason of B1344 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

Parts or components should not be replaced with reference to only a B1344 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

	Example: 0140